MEDIACENTO IPX 4KIP FIRMWARE UPGRADE

**************************IMPORTANT**************************
********PLEASE READ AND FOLLOW INSTRUCTIONS CAREFULLY********
*FAILURE TO FOLLOW INSTRUCTIONS CAN LEAD TO PRODUCT FAILURE*

V6.4.22.2
SUPPORTED PRODUCTS:
VX-HDMI-4KIP-TX
VX-HDMI-4KIP-RX

DOES NOT SUPPORT ANY OTHER UNITS

RELEASE NOTES:

**BE SURE TO LOAD THE CORRECT FIRMWARE ON THE CORRECT MODEL** 
********IT IS POSSIBLE TO LOAD THE INCORRECT FIRMWARE********
*********WHICH CAN RESULT IN DAMAGED OR FAILED UNITS********

ADDS COMPATIBILITY WITH THE FOLLOWING MEDIACENTO IPX MODELS:
VX-HDMI-4K-TX
VX-HDMI-4K-RX
VX-HDMI-HDIP-TX
VX-HDMI-HDIP-RX
VX-HDMI-POE-MTX
VX-HDMI-POE-MRX
UVX-HDMI-POE-TX
UVX-HDMI-POE-RX

ONCE UPGRADED, THE MEDIACENTO UNIT WILL NO LONGER BE COMPATIBLE
WITH UNITS RUNNING FIRMWARE LOWER THAN 6.4.22.X

UPGRADE PROCESS:
1. BROWSE TO THE IP ADDRESS OF THE UNIT TO BE UPGRADED
2. SELECT THE DROP DOWN FOR FIRMWARE UPGRADE
3. CLICK BROWSE AND SELECT THE APPROPRIATE FIRMWARE FILE
	MAKE SURE YOU ONLY USE THE TX FIRMWARE ON A TX UNIT
	AND RX FIRMWARE ON RX UNITS
4. DUAL FLASH ON EACH TX AND RX UNIT, UPGRADE BACKUP FLASH FIRST
5. ONCE YOU HAVE VERIFIED THAT YOU SELECTED THE APPROPRIATE FILE, CLICK THE UPGRADE BUTTON
	IT SHOULD TAKE LESS THAN A MINUTE TO UPLOAD THE FIRMWARE, BUT THIS WILL DEPEND ON NETWORK SPEED
6. FIRMWARE WILL BE UPLOADED TO THE UNIT
	ONCE UPLOADED, THE UNIT WILL INSTALL THE FIRMWARE, THIS MAY TAKE SEVERAL MINUTES
	DO NOT UNPLUG OR ATTEMPT TO REBOOT PRODUCT DURING UPGRADE PROCESS
7. UNIT WILL AUTOMATICALLY REBOOT WHEN UPGRADE IS COMPLETE
8. UPGRADE PRIMARY FLASH BY REPEAT PROCEDURE FROM 5 TO 7
9. ONCE UPGRADE IS COMPLETE, THE PRODUCT SHOULD SHOW THE NEW FIRMWARE VERSION